PRODUCT: 64664 XC RV 2 Bike Rack RV Towing Mount • Page 1 of 21. Unfold the two side arms as shown (diagram 1) and insert the lynch
pins. Ensure that the pins are all the way in.
2. Slide the 4 wheel holder trays on to the bottom arms alternating the direction of the trays (diagram 2). Do not tighten them at this time, as they will have to be adjusted to fit each bike that you are carrying. After the wheel holders are installed you will need to screw in the 2 metal screws at the end of each arm. This will prevent wheel holders from coming off.
3. Slide the hooks onto the upright portion alternating the direction (diagram 2).
4. Slide “L” shaped bar bar over your tow bar and insert into your receiver hitch (towing bar is not included) (diagram 2).
5. Tighten the two set-screws at the bottom of the square section of the bike rack. Then tighten the two set-screws on the bottom of the “L” shaped bar (diagram 3 & 4).
BIKE INSTALLATION:
1. Pull the pin on the bottom of the upright arm and fold down. This allows you to easily put the inside bike onto the rack (diagram 3).
2. Adjust the trays to the wheels of the bike so that they are all the way in the tray. Once these are adjusted tighten the knobs on the tray so that they are secure and cannot slide (diagram 5).
3. Fold the upright bar back into the upright position and insert the pin.
4. Push the hook down onto the bike. Press the red button below the hook to slide it more easily into place. Release the red button when the hook is securely holding the bike. Releasing the button locks the hook in place and prevents it from any upward movement while
in transit. Ensure the hook arm is fully locked into the notches on the upright arm.
5. Install the outside bike in the same manner.
NOTE: After complete installation check all pins and tighten knobs to ensure they are all tight and that the bikes are motionless on the rack.